Installing Asphalt Paving

The paving installation can be a very labor-intensive job. It can also be complicated if there are no specific steps taken with the preparation phase not completed properly. If the area is not quite ready and you are trying to put the asphalt will not be durable and smooth. Most owners hire a professional asphalt paving company with many years of experience to do this work and has references to prove it.
Marking the area
If you have a reverse road, the starting point could be next to the garage or at the end of what will be your entrance. Once you have chosen your starting point brand with a wooden stake in the ground. Continue to mark the area with a tape measure around the outer perimeter of the area. In each corner book on a wooden stake. To make sure the area is symmetrical, you can measure from one corner to the other, dial the numbers down, and continue at the four corners or you can use a laser level. If the numbers match then marked it is square and you are ready for the next step.
Method of preparation
Dig the area so that it is ready for gravel and asphalt. Take a rope from one wooden pole to another and dig the area in the chain at least twenty inches. You want to get as close as possible under the twenty inches. Use a compactor gas to make sure the area does not base and it creases ruin the asphalt by compacting the area. If the lower zone is not level, solid, or will.
Building a solid foundation
You will need an inexpensive way to build a barrier around the perimeter, making sure it flushes the wooden floor. You can use small stakes around the outside edges to secure the frame if you need too. Once the soil is compacted, you can begin this next step. At this time, if the owner has hired a professional asphalt paving company, which allow you to take them at that time at work. A layer of garden mesh will be stretched over the area and gravel levels will be made below. There will be five layers. Each layer is stabilized with a shovel or rake and compacted before the next level is placed.
Installation of asphalt
At the time of pouring the asphalt company will extend around to make sure it is properly tilted for water run-off. It was also compacted before it dries.

http://www.annonces.immo-reve.com/
https://www.facebook.com/immo.reve.tn